Tape one end of the template to the installation surface
with masking tape and unroll it. Level the template and tape
the other edge to the installation surface.
Step Two
Mark holes with center
punch, then drill 1/4"
holes 3" deep where
indicated on your template.
Remove the template
and clean out all drill
holes using any of
the following methods:
a quick puff of air;
using the vents on
your drill; compressed
air or a turkey baster.
Step Three
Insert the studs
into the stud holes
on the wall before
applying silicone to
verify position. Adjust
as necessary. Now fill
the drill holes in
the wall of the first
letter with silicone.
Step Four
Push the tube of
silicone over each
stud on the first letter
in order to evenly
coat it with adhesive.
Step Five
Push the letter into
the drill holes using
a shim to assure the
proper standoff of
the letter from the
wall. Secure to wall
using long strips of
tape. Remove tape after
silicone sets. Repeat
steps 3 through 5 for
the rest of the letters.
SW-SignLetters.com
Pad Mount
Installation
Step One
Clean the installation
surface first. Position
the spacing tape on
the wall and secure
one end with masking
tape. Unroll, level
and tape the other
end. Spacing tapes
show the general position
of each letter only
and are available free
upon request.
Step Two
Apply silicone to
all of the pads on
the first letter. Position
the letter on the wall
where indicated on
the spacing tape. Tape
the letter to the wall
with several strips
of masking tape.
Step Three
Adjust as needed;
push letter against
wall to insure good
adhesive bond. Continue
with the remainder
of the letters, and
allow the silicone
to sure for at least
10 minutes before removing
the masking tape. However,
we recommend overnight
curing for most conditions
and silicones.
